Форум




Mask Rom mode на Vigica V3  

  RSS

Участник Admin
Присоединился: 3 месяца назад
Сообщения: 174
04/11/2018 6:27 пп  

make sure drivers installed. Then tricky part locate pins 7/8 and will shorting them and pressing reset power up device will hooked up to pc with android tool open and running. (Tricky yes but possible) I used power bar that I turned on with my toe all hooked up look on chip closeclosely some times small in dent on the chip at 1 pin round depression? Once you do short and press reset switch and turn on you should see blue box in the rk tool. That means your in mask mode should be able to install stick rom from there. It's tricky but can be done.
Count from each side if you can't find 7/8


ОтветитьЦитата
Участник Admin
Присоединился: 3 месяца назад
Сообщения: 174
04/11/2018 6:27 пп  

The flashing process :
1. make sure you've installed rk3288 driver for your operating system
2. run rk batch tool (i used v 1.7)
3. disconnect all cables from android box
4. connect usb otg cable to pc
5. shorten marked chip pins on android box
6. connect only otg usb cable that is already connected to a computer to android box
7. turn android box on

if all is ok, you will see the port color change on the rk batch tool screen so it can flash the proper image on the android box


ОтветитьЦитата
Share: